Enclosure for your Honda Pioneer 1000-5 uses your existing hard roof and windshield.
This enclosure can be used as a complete enclosure for the 5 seat version or can be transformed to be used in the 3 seat option (front seat only), allowing full use of your rear bed.
This enclosure is made of heavy-duty ballistic material and installs easily. Sides attach with wraps around your roll cage and across the top of your factory door with your choice of self-adhesive snaps (no drilling required), or pop rivet snaps (drilling required).
Each window unzips from the bottom allowing the door to fully open without unsnapping any snaps. The windows also unzip from the top allowing the window to open for air or just reaching out of the UTV for doing things like retrieving mail, or opening gates, etc. The entire side can be removed in seconds to allow for removal in warmer weather. The back has a large window to provide an unobstructed view. Can be used in the rear position, or moved up behind the front seat as a middle window allowing full use of your dump bed.
After the initial installation of setting your snaps, etc. which takes less than 1 hour, the enclosure can be removed in just a minute and reinstalled in less than a minute.
It comes complete with everything needed for installation and free storage bag.
Please remember to make your choice of how you would like your enclosure to attach to your doors in the options above.
The manufacturer gives no guarantee on self-adhesive snaps or Velcro. Please note that Velcro and self-adhesive snaps can cause damage to decals if applied over decals. The enclosure is guaranteed 1 year for quality and workmanship. It will be repaired or replaced at the manufacturer's discretion, as long as the enclosure has not been abused.
Custom made in the USA!
All features may not be presented in the accompanying pictures. Description takes precedence over pictures. The manufacturer reserves the right to make modifications at any time.
